The new scrum master is working hard

Teaching by example!

Lovely!

I think pictures of said cat would be greatly appreciated 😉

You can double up the handles, which also spreads the load a bit so they don’t cut into your hand as much. It is mainly for compactness and easy marketing

It might be an issue with concentricity. If the nozzle is not perfectly centered it creates a step that the filament can snag on. It can then cause the already softened filament to bunch up during deretraction forming a plug in the heat break. I had this issue with cheap nozzles. Everything starts fine and after a few layers it all stops for apparently no reason. Cranking up the heat makes it better for a bit, before making it worse

Witty one-liner

Supergreen

Earmoofs

I hate it too. It should be life/work balance. Life comes first. Work to live, not live to work

Good bot Link updated

Brave sir Robin ran away https://piped.video/l8IkbCeZ9to