I’m currently working on a more complex project that uses double sided assembly (and a weird USB-C connector). To practice these things a little, I ordered some low cost boards to get used to that connector and explore double sided reflow (which seems easier than I expected).

For those who are interested, this is a reference design from framework computer for their expansion card system. It can be programmed with circuitpython or Arduino and utilises a SAMD21 microcontroller.

    • tbe@lemmy.worldOPEnglish
      0·
      1 year ago

      Yeah I have such a small, cheap Chinese one (T962) that I modified and flashed a nicer firmware on.

      I basically populated the bottom side (with more components) first after applying solder past with a stencil, then reflowed the board. After cooling down I applied the solder paste to the upper side (with the LED) by using a small needle on a syringe (because using a stencil was too weird since the board wasn’t laying flat) but since the pads are relatively large and not that many that worked fine. Then I placed the components on that side and simply run the reflow cycle again.

      I started with the bottom side because there are no heavy components. I expected heavy parts to just fall off on the second reflow cycle so I tried to avoid that.

      At the end I manually assembled the USB connector using a regular soldering iron and tons of flux gel.

      • CircuitGuy@lemmy.worldEnglish
        0·
        1 year ago

        I used a Chinese oven that looked just like that, maybe the same model. I found it uneven in its heating, so much so that paste near the door sometimes didn’t flow. It was possibly a step up from my Black and Decker toaster oven.

        • tbe@lemmy.worldOPEnglish
          1·
          1 year ago

          Mine is the smallest one of a series of these, it has two heating elements inside.

          I don’t have it for that long but I didn’t have problems so far, I’m usually only making rather small PCBs tho. I did make some recommended modifications like replacing the paper insulation tape with a kapton tape, proper grounding and flashed another firmware.

          I did only use a small hotplate and/or a hotair station, so it seems to be definitely a stepup here 😌.