• gamermanh@lemmy.dbzer0.com
    link
    fedilink
    English
    arrow-up
    25
    arrow-down
    1
    ·
    3 months ago

    God it’s posts like this that make me wanna fix my 3d printer

    Not for cigarettes but like, the dispensary near me sells the double blunt adapter for wayyyy too much and I could print one with the resin I have if my printer wasn’t a lil bitch about things, and a triple-chamber for a 3-strain hit sounds so goddamn fun

    • Honytawk@lemmy.zip
      link
      fedilink
      arrow-up
      25
      arrow-down
      1
      ·
      edit-2
      3 months ago

      Wouldn’t do that with resin though if you are going to put it in your mouth.

      Very toxic, even on skin.

      • gamermanh@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        16
        arrow-down
        1
        ·
        3 months ago

        The resin is used to make a mold for silicone by inverting the 3d model, I’ve done it for a couple of pipe ideas before to see if they’d be cool (I’m bad at 3d design is what I learned)

        I also know a guy who uses some EXPENSIVE resin that’s apparently safe to use in medical situations, so I assume breathing through that once it’s done with its treatment is probably fine, but I’d never do it with my cheap shit, even being in the room with it hurts with my mask on (hyperbole)

      • gamermanh@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        8
        arrow-down
        1
        ·
        3 months ago

        It fell out of alignment and no matter what I do it refuses to properly calibrate

        Every test print for a month failed no matter what I did because it wasn’t moving properly and contacting support got me less than nowhere

        If I ever get medicated again it’s on the list of shit to sit down and figure out cuz I bet a part is loose somewhere OR the firmware went insane and needs reinstall

    • Krauerking@lemy.lol
      link
      fedilink
      arrow-up
      3
      ·
      3 months ago

      Man I know that feeling. I have a prusa Mk2 that’s just… Funny about things and I’m so uninspired to fix it anymore but print ideas still come in from time to time that makes me want to figure it out.